OPERATION AND SERVICE INFORMATION
3-30
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
capacity or near capacity load applications will require 10W-40 oil after
a break-in (Ref Fig. 27 on page 3-30).
To reduce the possibility of severe
injury, wear rubber gloves to protect
skin from exposure to hot, used oil
and degreaser. These fluids contain chemicals known to
cause cancer.
The oil should be changed with the engine warm. Park the vehicle on a
level surface, engage the park brake and remove the key. Place a drain
pan under the engine. Wipe the top of the engine clean with a cloth (Ref
Fig. 28 on page 3-30). Remove the oil fill cap.
Clean the area around the filter. Oil drainage is accomplished by
removing the three bolts securing the oil filter to the engine. Remove
the filter by pulling it from the engine and allow the oil to drain. The ‘O’
rings may remain on the engine or the filter (Ref Fig. 29 on page 3-30).
At each oil change, thoroughly inspect filter before cleaning. At the first
oil change, metal chips and lint may be found. This is normal, resulting
from engine run-in. At subsequent oil changes, the presence of metal
chips may indicate possible engine damage.
Wear eye protection to reduce the possibility of
splashed solvent contacting the eyes when clean-
ing oil filter.
Fig. 27 Oil Viscosity Chart
-20
0
20
40
60
80
100
-30 -20
-10
0
10
20
30
40
C
F
0
0
10W-30
10W-30
HEAVY DUTY WORK
LIGHT DUTY WORK
(Air Temperature)
10W-40
10W-40
10W-30
10W-30
!
!
Fig. 28 Cleaning Top of Engine
Fig. 29 Remove Oil Filter
Oil Fill Cap
Oil
Filter
Small 'O' Ring Inside
End Of Oil Filter
Large
'O' Ring
Summary of Contents for EZGO Workhorse ST 350
Page 1: ...OWNER S MANUAL SERVICE GUIDE Starting Model Year 2003 R...
Page 60: ...5 6 LIMITED WARRANTY Notes...
Page 62: ...6 2 DECLARATION OF CONFORMITY Notes...
Page 71: ......
