OPERATION AND SERVICE INFORMATION
3-5
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
turning clutch knob 90°, returning it to original position (Ref Fig. 4 on
page 3-5).
To wind cable, use handsaver bar to keep tension on the cable while
activating remote. When winding cable, make sure the cable winds
tightly and evenly onto the drum leaving no gaps that could cause pre-
mature wear to the cable. When using winch under a load, operate the
remote control from as far to the side of the vehicle as possible. Do not
operate winch while sitting in passenger seat. Read the following sec-
tion (Winch Applications) before attempting to operate winch.
WINCH APPLICATIONS
The winch may be used for a number of purposes, including pulling the
vehicle if it loses traction on unsuitable terrain.
Improper use of the winch could
result in a number of conditions that
could cause severe injury or death
to operator, occupants of vehicle or bystander.
It is impossible to predict all conditions that the winch could be used,
therefore the following warnings should not be considered as complete.
Before operating the winch, consider the possible dangers and take
precautions to protect yourself, your passenger and any bystanders.
To prevent severe injury or death to
operator, occupants or bystanders,
select the object to which the cable
is attached with the following considerations:
Make sure the object cannot be pulled over or otherwise
damaged.
The object the winch is attached to could fall on the vehi-
cle and it’s occupants.
If attaching the winch to a dead tree, a section could fall.
When pulling vehicle with winch, pull straight only. Do not permit the
cable to contact the side of the drum.
Do not pull vehicle at angle. If the
vehicle is pulled at an angle, it could
turn over causing severe injury or
death to anyone in the area. The winch cable could also
become overstressed and break causing severe injury or
death to anyone struck by the cable.
Fig. 3 Winch Remote Control
Fig. 4 Winch Clutch Knob
Receptacle
Remote Control
Pull out
ENGAGED
Clutch Knob
LOCKED OUT
Turn 90
0
!
!
!
!
!
!
Summary of Contents for EZGO Workhorse ST 350
Page 1: ...OWNER S MANUAL SERVICE GUIDE Starting Model Year 2003 R...
Page 60: ...5 6 LIMITED WARRANTY Notes...
Page 62: ...6 2 DECLARATION OF CONFORMITY Notes...
Page 71: ......