OPERATION AND SERVICE INFORMATION
3-21
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
LIGHT BULB REPLACEMENT
For vehicles with headlights mounted in cowl, locate the two screws on
backside of cowl that secure headlight (Ref Fig. 20 on page 3-21).
Remove screws, pull headlight out and disconnect wires. Connect
wires to new headlight, install in cowl and secure with screws previ-
ously removed.
To replace the turn signal light bulb, support turn signal housing from
backside of cowl while removing two screws securing lens (Ref Fig. 20
on page 3-21). Install new bulb and replace lens.
To replace the tail and brake light bulb, roll the rubber bezel from
around the edge of the taillight and remove lens (Ref Fig. 21 on page 3-
21). Install replacement bulb and replace lens.
FUSE REPLACEMENT
To replace fuses, locate the fuse block under the driver side seat. Pull
out old fuse and replace with a new automotive type fuse. Headlight
Fig. 19 Wheel Installation
Tire style may vary
1
2
3
4
'Cross Sequence'
Front of
Vehicle
Rotat
io
n
Fig. 20 Headlight and Turn Signal Bulb Replacement
Fig. 21 Tail and Brake Light Bulb Replacement
Headlight
Bulb
Turn Signal Lens
Turn Signal
Housing
Inside
of Cowl
Rear
Fender
Tail/Brake
Light
Roll Rubber
Bezel Away
From Body
Summary of Contents for EZGO Workhorse ST 350
Page 1: ...OWNER S MANUAL SERVICE GUIDE Starting Model Year 2003 R...
Page 60: ...5 6 LIMITED WARRANTY Notes...
Page 62: ...6 2 DECLARATION OF CONFORMITY Notes...
Page 71: ......
