INSTALLATION
PAGE 7
DOOR SENSOR
Switch on: If the Door Sensor was supplied with the Main Sensor it will already be
paired, you just need to switch it on by pressing the Help Button. The white LED will
flash.
Adding an additional Door Sensor is similar to the above except: After a few seconds the
Main Sensor will display the Door Sensor in its sensors menu. The sensor can now be
renamed, see advanced setup. The Main Sensor will go to the sensors display and will
show the default name DOOR the sensor number will be added to the default name. So a
door sensor added in the sensor 2 position will be assigned the default name DOOR2
and to 3 would be DOOR3 etc.
Fix in position: The Door Sensor should be fixed to the outer edge of a door, ideally high
up above the handle so it will not be knocked. Fix to the door using the pre fitted ‘stick-
on-Velcro-pad’.
NB Do not position near other electrical devices such as heating
controllers, phones, radiators, etc.
DOOR SENSOR RESET
If a problem occurs then it may be necessary to reset the sensor. Press and hold down the
HELP button. The LED will start flashing. Keep holding down and after approximately 5
seconds the LED will turn off. Keep holding the button down until a further flash is seen,
then release. The Door Sensor is now reset, the pairing will be cleared and the sensor
switched off. You can now add this in the same way you add an additional sensor, as
described above.
Help
Button
LED
