Texas Instruments TMS3637P, Data Manual

Page: 11 / 53

2–1
2 Specifications
2.1 Absolute Maximum Ratings Over Operating Free-Air Temperature Range
(Unless Otherwise Noted)
†
Supply voltage range, V
CC
(see Note 1) – 0.6 V to 7 V . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Input voltage range (except OSCC), V
I
– 0.6 V to V
CC
+ 0.5 V . . . . . . . . . . . . . . . . . . . . .
Input voltage range, OSCC, V
I
– 0.6 V to 15 V . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output voltage range, OUT, V
O
– 0.6 V to 15 V . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating free-air temperature range, T
A
–25
°
C to 85
°
C . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range, T
stg
– 65
°
C to 150
°
C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These
are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated
under “recommended operating conditions” is not implied. Exposure to absolute-maximum-rated conditions for
extended periods may affect device reliability.
NOTE 1: Voltage values are with respect to GND.
2.2 Recommended Operating Conditions
MIN NOM MAX UNIT
Supply voltage, VCC 3 6 V
High-level input voltage, VIH VCC – 0.5 VCC V
Low-level input voltage, VIL 0 0.5 V
Operating free-air temperature, TA – 25 85
°
C
Receiver supply current, analog, ICC(an) 2 mA
Receiver supply current, digital, ICC(dig) 200
µ
A
Transmitter supply current, standby, ICC(stdby) 13
µ
A
Transmitter supply current, code transmission,
ICC(code) 260
µ
A
Programming current at OSCC, IOSCC 100
µ
A
Oscillating period, tp0+ tp1 (see Figure 3–1) 10 1/(fosc) 200
µ
s
Pulse duration, logic 1 bit, tw1 (see Figure 3–1) 5 tp1 100
µ
s
Pulse duration, logic 0 bit, tw2 (see Figure 3–1) 35 3 x tp0 + 4 x tp1 700
µ
s
Setup time, transmitter/receiver external clock on
OSCC
↓
and before IN
↑
, tsu1 (see Figure 3–2)
152
19
×
tw1
(receiver)
µ
s
Pulse duration, IN high, tw3 (see Figure 3–2) 48
6
×
tw1
(receiver)
RTIME
×
CTIME
(see Note 2)
µ
s
NOTES: 2. RTIME is the value of the pullup resistor on TIME and CTIME is the value of the capacitor in parallel with
RTIME. CTIME should not exceed 3
µ
F.