Texas Instruments TMS320DM6437, Getting Started Manual, Page: 45 / 64

Using the FlashBurn Utility
Additional Procedures A-5
14) Click the Burn icon or choose Program->Program Flash .
The status bar next to the Burn icon shows the progress of the
operation. The status bar of the window shows the result of the
operation when it is complete.
15) If the burn fails, do a complete erase of the NOR region, and then try
again.
16) When you are finished, close FlashBurn, press Alt+C to disconnect
CCStudio from the board, and power off the board. (You may save
the FlashBurn configuration file if you wish.)
17) Set the SW1 and SW2 switches as follows:
18) Turn the board on. Your application should start. Note that the AIS
image format can only initialize the DDR memory (and the associated
PLL2), the system PLL (PLL1), the AEMIF interface, and the
PINMUX registers. Other required initialization steps (such as turning
on power domains) must take place in the user application.
= switch location