Texas Instruments SWRU197E, User Manual

Page: 3 / 24

swru197e
3/23
1 Introduction
The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based
System-on-Chip (SoC) devices from Texas Instruments. The PC tools available for these purposes are
the
SmartRF™ Flash Programmer from Texas Instruments and IAR Embedded Workbench® for 8051
from IAR Systems.
When connected to the debugger, the SoC devices can be controlled directly from
SmartRF™ Studio.
SmartRF Studio will also be able to control supported CCxxxx RF transceivers (CC2520, CC112x, and
CC11xL) when they are connected to the debugger as explained in chapter 6.3.
In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless
Configurator.
2 Abbreviations and Acronyms
CSn Chip Select (active low)
DC Debug Clock
DD Debug Data
DUT Device Under Test
GND Ground
LED Light Emitting Diode
MISO Master In Slave Out
MOSI Master Out Slave In
RF Radio Frequency
SCLK Serial Clock
SoC System on Chip
SPI Serial Peripheral Interface
USB Universal Serial Bus
Vdd Positive voltage on target