50
September 5, 2010
Widget-based touchscreen user interface
Screen capture to SDCard or USB stick in Windows bitmap (BMP) format
Brightness, saturation, tint/hue, and sharpness picture controls
Mirror/Flip/Normal Picture controls
Installation
To install the expansion board on the DK-LM3S9B96 development board, do the following:
1.
Remove the LM3S9B96 FPGA memory expansion board from the antistatic bag.
2.
On the DK-LM3S9B96 board, remove any installed board on EPI connector J2.
3.
On the DK-LM3S9B96 board, remove the shunt jumpers on JP16-JP31 and the JP39 headers
as shown in Figure F-1 on page 49.
4.
Place the expansion board on top of the DK-LM3S9B96 board and press firmly downward until
the board snaps in.
5.
Connect the the male EPI expansion connector on the bottom side of the FPGA expansion
board to the female EPI expansion connector on the DK-LM3S9B96 development board (J2).
The LCD header pins should fit through the holes on the PCB.
6.
Use the included jumper wire to provide 5 V power to J5 from any of the three upper pins
immediately below and to the right of the EXT+5V connector on the development board.
7.
When powering up the board, verify that the power indicator LED D1 is lit.
Summary of Contents for Stellaris LM3S9B96
