Start-up Sequence
2-6
2.2
Start-up Sequence
The startup sequence for the ADSDeSer-50EVM is as follows:
Step 1: Connect the ADC board to the input connector (Con1).
Step 2: Connect the clock and data outputs to a data capture system
(analyzer).
Step 3: Apply power to the ADSDeSer-50EVM board and look for the Power
On (DS1) LED and DS2 LED to illuminate. If DS2 does not illuminate,
press the Program (S1) pushbutton. If no LEDs illuminate, contact
TI customer support for help.
Step 4: Read data from ADSDeSer-50EVM.
If during operation a condition occurs that is unexplainable, press FPGA_RST
(S2) to restart the FPGA program. If the condition still persists, contact TI cus-
tomer support for further assistance.
Summary of Contents for ADSDeSer-50EVM
