21
How to use the snow blow
When stopping
The sparks that may appear when stopping the machine are caused by the braking system and are not dangerous.
Before using the machine, please make sure:
The power source you will use is in accordance with the specifications shown in this user s manual.
Before inserting the plug into the socket, make sure the machine s roll shaft and the snow blow rubber plates are all fixed firmly
with screws, and the rubber plates are facing to the correct direction.
1.First, push the double safety switch at the rear side of the handle.
2.While pushing down and holding the rear double safety switch, push down
and hold the other double safety switch.
3.Push down and hold both the two safety switches at the same time, the snow
blow will start and then you can begin your blowing work.
I f you don t push down and hold both the two switches at the same time, the
machine will not start, even though the power cable is connected properly.
Only when you push down both the two switches at the same time the machine
can be started.
When moving the machine, use the wheels on one side as the pivot point,
making the machine slightly tilt and move forward or backward.
While moving the machine, do NOT drag the power cable violently and roughly,
the machine should move within the range that the cable can reach.
DO NOT push the snow blow with much force, you should push the machine
moving gently and evenly.
DO NOT apply additional man-made load to the engine,
otherwise, it may cause damage to the engine.
Special care should be taken while operating the machine.
Cautions!
When moving backwards, be cautious about any
obstacles beneath your feet.
While moving forwards or backwards, you should also
be cautious about nearby people and obstacles to
avoid possible damages or injuries. Additionally, be
careful not to make the cable tangled with the moving
machine.
When using a lengthening cable, the cable should be
water- proof with rated current of 8A or higher.
