17
Precautions specific to Snow Buster 310
In the above chapter we examined some common warnings and cautions for the Snow Buster 310, in the below chapter
some key precautions specific to the Snow Buster 310 are mentioned, which should be observed and obeyed strictly.
19.The user should maintain the machine on a regular basis
To ensure safe and effective operation of the machine, the
user should maintain the machine on a regular basis
If you find the main power cable or the lengthening cable
damaged, please pull out the plug from the socket and
disconnect the power immediately. Repair the cable or
replace it if necessary.
When adding the lubricant or replacing any parts, you must
strictly observe the instructions and procedures described in
this User Manual.
Special care should be payed to any rubber parts, since
these parts may increase the engine load and decrease its
mechanical power if damaged.
20.When operating the machine, the user must hold the handles
firmly with TWO hands.
21.Do NOT overload or add load when operating the
machine.
Please use the machine strictly observing the data
indicated in the acceptable mechanical specification
range. Using the machine with overload may be one of
the direct reasons for engine damage.
22.Repair and service of the machine should be undertaken
at designated professional shops/your dealer.
All features and components of the machine meet the
specifications and design targets, no machining
process or improper changes should be made to the
machine.
In case you find any defaults or damages, please
contact your original distributor immediately.
1.The power source you will use for the snow blow must meet
the rated voltage shown in the specification table.
If the power voltage you use exceeds the rated voltage
range, the engine will become overheated which may
cause damage to the machine and personal injury.
2.When moving or transporting the machine, do NOT hold the
handles only.
3.When you examine, service, clean the machine or replace
parts, you must turn off the power switch and disconnect the
power cable. Any such operation should be performed after
the revolving part inside the machine stops completely.
Additionally, at the end of each work shift, you should also
disconnect the power cable from the socket.
