Texas Equipment Pro Chainsaw 300, User Manual

Page: 18 / 28

18
1. Check the spark plug as follows.
2. Turn the machines ignition switch to "stop".
3. Remove the spark plug spark plug.
4. Brush the dirt and sawdust from around the spark
plug.
5. Remove it with a spark plug wrench.
6. Check, clean or replace if necessary.
7. Install the spark plug safely and place the spark
plug cap on the spark plug.
Number of new spark plugs: 10011022
Maintenance of bar and chain
Lubrication hole (Fig. 20).
Dismount bar and control
on
Bolthole (1) is blocked with sawdust or dirt. Lubricate
with oil / grease.
Swords (Fig. 21) . Clean the nose wheel and running
path for dirt. Turn any sword to distribute the wear. A
worn bar can be dangerous to use, and should be
replaced.
Chain (Figure 23-24) . Chain should be filed regularly
for best results.
1. Make sure the bar is tightened properly.
2. Use a 4.8 mm (3/16 ") file.
3. File all the teeth with 3-4 coats , so they are
equal, as shown in the drawing.
4. It is necessary to regularly inspect the height
of the teeth if they are too high, they should be
filed with a flat file (provided not).
Maintenance intervals
Storage
1. Drain all fuel from tank into a container approved
for gasoline.
2. Start the machine and let it run until all fuel is
used.
3. Allow machine to cool
4. Remove the spark plug
5. Pour 1 teaspoon of 2-cycle oil into the spark plug
hole.
6. Pull slow in recoilline 2-3 times, this distribute
the oil in the engine.
7. Remove the spark plug safely and set spark plug
cap firmly.
8. Store the engine in a dry place
9. Comply with all relevant safety instructions due
to safe storage and handling of gasoline.
Technical Specifications.
Part Action After
Screws / Bolts
Check /
Tighten
Each Use
Air Filter
Clean /
Replace
Every 10. hours
Fuel filter Replace Every 20. hours
Sword / Drive
wheel
Clean Every Need
Spark Plug
Clean / Adjust
/ Replace
Every 20. hours
Fuelhose Check Every 20. hours
Chain Brake Check Each Use
Model Pro Chainsaw 300
Cylinder displacement
56 cc
Net power 2,35 kW (8.000 omdr./min.)
Starter Elektronisk
Fuel
Olimixed 40:1 (2,5%):
Oktan 95 og 2-stroke oli
Tank (fuel) 550 ml
Tank (chainoli) 260 ml
Chain Lubrecation Chainoil SAE 30
Anti-vibration Yes
Weight 5,1 kg
Bar 20” / 50 cm
Bar type Oregon Pro-Am .325” 20”
Chain type
Oregon 0.325 62 Link 1,5
MM Track Wide
Chain Breake Yes
Hand Screen Yes
Spiked bumber Yes
Chaincatcher Yes
LWA Guarenteed 115 dB(A)
Vibrationer
Front håndtag: 8,7 m/s
2
Bag håndtag: 9,9 m/s
2
K = 1.5 m/s
2