26
• POWER HIFI
Software Update
The software of the POWER HIFI is being continually
developed. You can download subsequent versions
from our website.
Installing new software
1. Load the new software from our website.
2. Unpack the downloaded file.
3. Pull the mains plug of the POWER HIFI and wait
until the power indicator
(18)
is off.
4. With a USB cable, connect your PC or Mac to the
USB jack
(19)
of the POWER HIFI.
5. Push and hold the buttons POWER
(11)
and
SOURCE
(16)
at the same time and insert the
mains plug of the POWER HIFI back into the socket.
Continue to hold the buttons down until the power
indicator
(18)
blinks rhythmically.
6. A USB drive “POWER HIFI” will be displayed on your
PC now. There, you will see a file “version.txt”, from
which you can determine the currently installed
version.
7. At this point, you can still cancel the update without
risk by interrupting the USB connection to the PC.
NOTICE
Risk of damage!
–
During the following steps, the
POWER HIFI must not be switched off and
the USB connection must not be inter-
rupted!
8. Copy the unpacked update file on your PC to the
“POWER HIFI” drive.
The update will now run automatically. The power
indicator
(18)
will continue to blink rhythmically.
9. Once the update is complete, the POWER HIFI will
switch to standby.
At the same time, the USB connection to the PC will
be interrupted, which may cause an error message
on the PC. Ignore this message if applicable.
10. Pull the mains plug of the POWER HIFI again and
wait until the power indicator
(18)
is off.
11. Connect the POWER HIFI to the power supply
again.
The new software was installed.
08
(16)
(11)
(18)
(19)
