10
• POWER HIFI
Remote Control
Inserting/changing the batteries
The remote control is powered by 2 type AAA
batteries.
1. To open the battery compart-
ment, carefully unscrew the lid
off – it is slightly under tension
from the springs.
2. If applicable, remove the old
batteries and dispose of them
in an environmentally-friendly
manner.
3. Slide the new batteries into the
battery compartment according
to the image on the back of the
remote control.
4. Screw the lid back closed – it only fits the right
way around and is slightly under tension from the
springs.
NOTICE
When inserting the batteries in the compart-
ment, make sure that the polarity is correct.
CAUTION
Batteries can explode if handled improperly.
–
Never attempt to recharge batteries.
–
Only use batteries of the same or equiva-
lent type.
–
You must not heat, short circuit batteries
and rechargeable batteries, dispose of
them in fire or expose them to direct
sunlight.
–
Leaking battery acid may lead to chemical
burns.
–
Do not allow battery acid to come into
contact with skin, eyes or mucous
membranes. In the event of contact with
acid, immediately flush the applicable
areas with plenty of clean water and
consult a physician if necessary.
(32)
Select Bluetooth® source,
pushing and holding: Start pairing
(33)
Mute on/off
(34)
+
Increase the volume
(35)
–
Reduce the volume
(36)
MID
Adjust the mid-range level
(37)
TREBLE
Adjust the high range level
(38)
LINE
Select LINE IN as the analogue
source
(39)
USB
Select PC as the source via the
sound card
(40)
BALANCE
Set the sound level ratio on the
left/right
(41)
OPT
Select OPT IN as the digital
source
(42)
AUX
Select analogue source AUX IN
(43)
BASS
Adjust the low-range level
(44)
Start/pause playback
(45)
Skip track forward/back
(46)
Switch the device on and to
standby
Pushing and holding forces
the device to switch to
standby (useful with multiple
POWER HIFI).
(32)
(33)
(34)
(35)
(37)
(38)
(42)
(39)
(41)
(40)
(36)
(43)
(46)
(44)
(45)