14
• POWER HIFI
Operation
Activating and deactivating
–
By pressing the Power button
(11)
or
(46)
, you
switch the POWER HIFI on.
After switching the device on in master mode, the
last active audio source and volume will be set
(max. 25).
The power indicator
(18)
goes out, the LED
(14)
for the active source will light up and the display
panel
(12)
will show the volume within a range from
0–100.
–
By pressing the Power button
(11)
or
(46)
again,
you switch the POWER HIFI to standby. The power
indicator
(18)
is illuminated in a dim red now.
–
By pushing and holding the button
(46)
, you also
securely switch multiple POWER HIFI to standby.
This is particularly useful in master/companion
mode: Hold the button down and target the
POWER HIFI one after another. They will then switch
off.
Automatic activation/deactivation
You can enable automatic activation and deactivation
with the AUTO POWER switch
(23)
:
OFF – automatic disabled
ON – automatic enabled
• If the POWER HIFI does not receive an audio
signal and if there is no operation for more than
20 minutes, it will automatically switch to standby.
• As soon as a signal is detected on an audio source,
the POWER HIFI will also wake up and switch to the
detected audio source.
With the AUTO ON SENSITIVITY control
(28)
, you can
adjust the sensitivity from which the activation func-
tion is to recognise an audio signal:
•
LOW
: The sensitivity is set to low. Thus, an input
signal is only considered at high input levels and
the POWER HIFI will wake up.
•
HIGH
: The sensitivity is set to high. Thus, an input
signal is already considered at low input levels and
the POWER HIFI will wake up.
08
(11)
(14)
(12)
(18)
(46)
(23)
(28)
