Shenzhen TestPad Electronic Co., Ltd.
http://www.test-pad.com
20
Capacity Test
Select
Capacity Test
from the main menu to set the battery capacity parameters, as shown
below.
Selecting whether to test over-charge/over-discharge
1.
Items 1~3 are the same as those on the static parameter setting interface. Refer to Static Test.
2.
Lion OC/OD: For Li-ion battery, select YES to enable the over-charge/over-discharge test.
.....................
Selecting whether to discharge
.....................
Nickel-Cadmium battery before charging it
3.
If the current battery type is Nickel-Cadmium battery, the fourth menu item is “4.NiCd
PRE_DIS: NO”. Set whether to discharge the Nickel-Cadmium battery before charging it so
as to eliminate the memory effect of the battery and ensure accurate measurement.
4.
If the current battery type is Nickel-Metal hydride battery or SLA, the fourth menu item is
unavailable.
After you pressing ENTER, the tester follows the process below to test the capacity of the battery.
Pre-discharge (if the current battery type is Nickel-Cadmium battery and pre-discharge is enabled)
→
→
→
→
Fully charge the battery
Over-current test (if the current battery type is Li-ion battery and over-charge test is enabled)
→
→
→
→
Wait 100 seconds
Fully discharge
→
→
→
→
Over-discharge test (if the current battery type is Li-ion battery and
over-discharge test is enabled)
→
→
→
→
End
->1. Pack type:
Lion
2. Pack Vol:
3.6V
3. Pack Cap:
500mAH
4. Lion OC/OD:
NO
->1. Pack type:
NiCd
2. Pack Vol:
3.6V
3. Pack Cap:
500mAH
4. NiCd PRE_DIS:
NO
