Multi Station
Vicat Test Apparatus
34
5.2.1 Setting the coordinates of washing unit
Setting or Readjusting the coordinates of the washer unit is necessary when the needle or the cone does
not hit the center of the opening of the washer unit. The immersion depth of the needle or cone can also
be readjusted.
Figure 33: selection window set coordinates of washing unit?
Press
“1” button
to access the window for setting the washing unit coordinates (
).
Press
“2”
button
to bypass the window for setting the coordinates of washing unit and go to the next win-
dow.
The next window may prompt you to set the coordinates of the dryer (Fehler! Verweisquelle konnte nicht g
efunden werden.), if a washer for cone was activated or to set the coordinates of sample 1 (
By repeatedly pressing the
“2” button
, you will be successive guided to the other windows for setting the
coordinates of the other samples until finally to the window for determination of zero levels.
Press
“3” button
if you want to go back to the previous window.
Press the
“C” button
to exit the special menu for setting the coordinates.
The machine performs a reference search and goes into readiness.
Figure 34: setting the coordinates of washing unit at position 1
To set the coordinates of the washing unit proceed as follows:
Select an axis:
Press
button “1”
to select
X-axis
Press
button “2”
to select
Y-axis
Press
button “3”
to select
Z-axis
Modify the coordinate of the selected axis by pressing:
Button “B”
moving towards reference point
Button “F”
moving away from reference point
Save the coordinates of the selected axis by pressing:
Button “E”
the coordinate is saved to the EEPROM and is immediately effective
Quit the window to return to previous window by pressing:
Button
“C”
Washer at Position 1
Set coordinates?
yes: 1 back: 3
no: 2 cancel C
Washer at Position 2
Set coordinates?
yes: 1 back: 3
no: 2 cancel C
Washer at Position 3
Set coordinates?
yes: 1 back: 3
no: 2 cancel C
Set Pos1 coordinates
X: 1 B< F> E C
Y: 2 B< F> E C
Z: 3 B< F> E C
