Tesla TA71FFUL-2432IAW, User Manual

Page: 19 / 252

19
ENG
COOL mode
Ideal for hot muggy weather when you need to cooling and dehumidify the room.
To set this mode correctly:
• Press the
button a number of times until the “Cool“ symbol appears.
• Select the target temperature18 º C-32 º C (64 º F-90 º F) by pressing the or button until the corresponding
value is displayed.
• Select the required fan speed by pressing the button.
Four speeds are available: High / Medium / Low / Auto.
The most suitable temperature for the room during the summer varies from 24
º C to 27 º C (75 º F to 81 º F). You
are recommended, however, not to set a temperature much below the outdoor temperature. The fan speed
difference is more noticeable when the appliance is under Fan mode but may not be noticeable under Cool
mode.
HEAT mode
“ * “ means only the heat pump model have this function.
To set this mode correctly:
• Press the
button a number of times until the “Heat” symbol appears.
• Select the target temperature13 º C-27 º C (55 º F-81 º F) by pressing the or button until the corresponding
value is displayed.
• Select the required fan speed by pressing the button.
Four speeds are available: High / Medium / Low / Auto.
• Water is removed from the air and collected in the tank.
• When the tank is full, the appliance shuts down and “
” (full tank) appears on the display. The tank cap
must be extracted and emptied. Run off all water left into a basin. When all the water has been drained, put
the cap back in place.
• When the tank has been emptied, the appliance starts up again.
NOTE
• When operating in very cold rooms, the appliance defreezes automatically, momentarily
interrupting normal operation. During this operation, it is normal for the noise made by the
appliance to change.
• In this mode, you may have to wait for a few minutes before the appliance starts giving out
hot air.
• In this mode, the fan may operate for short periods, even though the set temperature has
already been reached.
FAN mode
When using the appliance in this mode, the air hose does not need to be attached.
• Press the
button a number of times until the “Fan” symbol appears.
• Select the required fan speed by pressing the button.
Three speeds are available: High / Medium / Low.
DRY mode
Ideal to reduce room humidity (spring and autumn, damp rooms rainy periods, etc).
In dry mode, the appliance should be prepared in the same way as for cool mode, with the air exhaust hose
attached to enable the moisture to be discharged outside.
To set this mode correctly:
• Press the
button a number of times until the Dry symbol appears.
• The fan speed is auto fan speed, and can not be changed.