Tesla TA71FFUL-2432IAW, User Manual

Page: 22 / 252

22
ENG
WATER DRAINAGE METHOD
When there is excess water condensation inside the unit, the appliance stops running and shows “ ” (FULL
TANK as mentioned in SELF-DIAGNOSIS). This indicates that the water condensation needs to be drained using
the following procedures:
Water may need to be drained in high humidity areas
1 .Unplug the unit from power source.
2. Place a drain pan under the lower drain plug. See diagram.
3. Remove the lower drain plug.
4. Water will drain out and collect in the drain pan (maybe not
supplied ).
5. After the water is drained, replace the lower drain plug firmly.
6. Turn on the unit.
While using the unit in dehumidifier mode, continuous drainage
is recommended.
1. Unplug the unit from the power source.
2. Remove the drain plug. While doing this operation some
residual water may spill so please have a pan to collect the
water.
3. Connect the drain hose (1/2” or 12.7mm, maybe not
supplied). See diagram.
4. The water can be continuously drained through the hose into
a floor drain or bucket.
5. Turn on the unit.
Manual Draining (Fig.12)
Continuous Draining (Fig.13)
Fig. 12
Drain
outlet
Drain cap
Drain pan
Fig. 13
Drain outlet
Drain cap
Drain hose
• Please be sure that the height of and section of the drain hose should not be higher than that of the drain
outlet, or the water tank may not be drained. (Fig. 14 and Fig.15)
NOTE
Fig. 14 Fig. 15