Removing the
Maintenance Panel
To check fluid levels, remove the maintenance
panel:
1. Open the hood.
2. Pull the maintenance panel upward to
release the clips that hold it in place.
3. If checking the Battery coolant, remove
the cabin intake trim panel by pulling it
upwards to release the clips that hold it in
place.
CAUTION:
The maintenance panel
protects the front trunk from water.
When re-attaching, make sure it is
fully seated.
Checking Battery Coolant
Your Battery coolant should not need to be
replaced for the life of your vehicle under
most circumstances. However, if the quantity
of fluid in the cooling system drops below the
recommended level, the touchscreen displays
a warning message. Stop driving Model 3 as
soon as safety permits and contact Tesla.
Fluid Level Check
DO NOT REMOVE THE FILLER CAP AND DO
NOT ADD FLUID. Doing so can result in
damage not covered by the warranty.
Do Not Top Up Battery Coolant
WARNING:
Battery coolant can be
hazardous and can irritate eyes and
skin. Under no circumstances should
you remove the filler cap and/or add
coolant. If the touchscreen warns you
that the fluid level is low, contact Tesla
immediately.
To maximize the performance and life of the
Battery, the cooling system uses a specific
mixture of G-48 ethylene-glycol coolant
(HOAT). Contact Tesla for more specific
information about the coolant.
Checking Brake Fluid
WARNING:
Contact Tesla immediately
if you notice increased movement of
the brake pedal or a significant loss of
brake fluid. Driving under these
conditions can result in extended
stopping distances or complete brake
failure.
A red brake indicator on
the touchscreen alerts you
if the quantity of fluid in
the brake reservoir drops
below the recommended
level. If it displays while
driving, stop as soon as
safety permits by gently
applying the brakes. Do
not continue driving.
Contact Tesla immediately.
Topping Up the Brake Fluid
Do not top up your brake fluid. The following
instructions are provided for information
purposes and future reference only:
1. Clean the filler cap before removing it to
prevent dirt from entering the reservoir.
2. Unscrew the cap and remove it.
3. Top up the reservoir to the MAX mark
using the appropriate brake fluid.
4. Replace the filler cap, ensuring it is fully
secured.
Fluid Reservoirs
214
MODEL 3 OWNER'S MANUAL
Summary of Contents for MODEL 3 2020
