14
www.tescom-ups.gr
NEOLINE
PRO
�
1/1
�
1-3 kVA
�
ONLINE UPS
USER MANUAL
14
ON, it means there is bypass output when power on.
⚫
Press the ON key for more than half a second to start the UPS, then it will start
the inverter.
⚫
Once started, the UPS will perform a self-test function. When the self-test
finishes, it will turn to online mode.
> Turn on the UPS by battery without mains power
⚫
When main power is disconnected, press the ON key for more than half a
second to start UPS.
⚫
The operation of UPS startup process is almost same as above process with
mains power. After the self-test finishes, UPS will work in battery mode.
Turn off the UPS
> Turn off the UPS in Line mode
⚫
Press the OFF key for more than half a second to turn off the UPS.
⚫
After UPS shutdown, there is no output. If output is needed, you can set BPS
‘ON’ on LCD setting menu.
> Turn off the UPS in battery mode without mains power
⚫
Press the OFF key for more than half a second to turn off the UPS.
When UPS shutdown, it will do self-test first, until there is no display on the
panel.
UPS self-
test/mute test
operation
⚫
When UPS is in LINE Mode, press the self-test/mute key for more than 1
second. UPS gets to self-test mode and tests its status. It will exit automatically
after finishing test.
⚫
When UPS is in BAT Mode, press the self-test/mute key for more than 1
second, the buzzer stops beeping. If you press the self-test/mute key for one
more second, it will restart to beep again.
UPS Setting
⚫
Enter Setup interface. Press and hold the function setting key
for more
than 2 seconds, then come to Setup interface, press and hold the inquiring key
(
,
) for more than half a second(less than 2 seconds), select the
function setting, choose the setup interface, at the moment, the letters flash.
⚫
Enter thesetup interface. Press and hold the function setting key
for
more than half a second(less than 2 seconds), then come to the setup
interface, at this time, the letters doesn’tflash any more,the numerical value
flash. Press and hold the inquiring key (
,
) for more than half a
second (less than 2 seconds), select the numerical value in accordance with
the function.
⚫
Confirm the setup interface. After selecting numerical value, press and hold
the function setting
for more than half a second (less than 2 seconds).
Now, the setting function is completed and the numerical value illuminates
without flashing.
⚫
Exit from the setup interface. Press and hold function setting key
for
more than half a second (less than 2 seconds), exit from the setup interface
and return to the main interface.
Note:
⚫
UPS could not be set until it is connected to the battery and it is turned off and
switched to Stdby mode (standby mode).
