TerraTec PHASE 26 USB, Manual

Page: 21 / 48

Analog outputs.
The analog outputs operate with musician-friendly line levels of
+4dBu (typically 2.1 volts
RMS@1 kHz). Here, you can connect a
mixing board, active speakers, or amplifiers. The number of us-
able analog outputs on the PHASE 26 USB System depends on
the selected configuration.
The back. The back of the PHASE 26 USB System is equipped with 6 high-quality analog
outputs, 2 or 6 of which are available at the same time depending on the operating mode,
and all of which are addressable independently. The connections are cabled using
RCA/cinch jacks.
The front. The front of the module provides one more analog output (LINE OUT), which
is switched in parallel to output 1+2 on the back of the module.
In the driver as well as the PHASE ASIO ControlPanel, the outputs are always treated as
pairs (thus, for example 1+2, 3+4, 5+6). In conjunction with common audio software, the
channels can be addressed individually.
The output level of all channels is set to approxi4dBu (typically 2.1 volts
RMS@1kHz) and also offers sufficient headroom if required in your productions.
Practical tip: Make full use of the 24-bit support of up-to-date
software applications and connected digital peripherals - even if
you are planning to “just” release your production on CD. The
additional sound quality is audibly worthwhile, both in the sum of
the signals and, above all, during digital post-production.
PHASE 26 USB (English) 21