Document 57.4402.8200 - 1
st
Edition 03/2007
INDEX
2
47
GYRO 4020 - 4518
TECHNICAL SPECIFICATIONS
2.26 CONTROLLING AND SETTING THE
MACHINE WITH WINSCOPE
In order to control the system, you shall install 2
programmes:
- CAN VIEW
- WINSCOPE
CAN VIEW
is a tool which lets you display the messages
relevant to the CAN network and to interact with the
relevant units connected.
WINSCOPE
is a programme which lets you display
the state of the machine and modify some parameters
relevant to the speed of some movements of the
machine boom.
- Configuring the machine: installing and
configuring the software
Once the
CAN VIEW
programme has been installed on
the PC, you shall configure the same so it can “see” the
CAN network.
This operation shall be performed on each single PC
unless, for some reasons, the set parameters are
changed.
To set the network, launch the programme from the
START => Programmes => PCAN => NetConfig.
menu.