May 2015
88 GTH 4016 R - GTH 4018 R - GTH-5021 R Part No.
57.0009.0607
Second Edition - First Printing
Maintenance
A-4
Lubricate the Boom
Genie specifications require that this procedure be
performed every 8 hours or daily, whichever comes
first.
Greasing the specified locations is essential for good
machine performance and service life.
Operating the machine with little or no grease may
cause the machine to perform poorly and continued
use may cause component damage.
1 Fully extend and raise the boom, then retract the
boom, checking to insure it operates smoothly.
There should be a light film of lubricant on wear
pad contact surfaces.
¤
Result: Boom operates smoothly and a thin film
of lubricant is visible. Proceed to step 5.
V
Result: Boom does not extend or retract smoothly
and no lubricant is visible on wear pad contact
surfaces. Proceed to step 2.
2 Apply a thin layer of grease to the underside of
the number 3 boom tube where it makes contact
with the number 2 boom tube lower wear pads.
3 Apply a thin layer of grease to the underside of
the number 2 boom tube where it makes contact
with the number 1 boom tube lower wear pads.
4 Lubricate the top and side boom tube wear pads.
5 Return the boom to the stowed position.
Grease Specification
PTFE INTERFLON FIN GREASE LS 2
Genie part number
09.4693.0000
A-5
Perform Engine Maintenance -
Perkins Models
Note: Engine specifications require that this procedure
be performed every 8 hours or daily, whichever
comes first.
Engine oil level - check
Coolant level - check/add
Fuel system filter/water separator - drain
Engine tightness - check for leaks
Exhaust system - check for leaks
Required maintenance procedures and additional
engine information is available in the
Perkins 1104D Operation and Maintenance Manual
(Perkins part number SEBU8172-02),
Perkins 854 Operation and Maintenance Manual
(Perkins part number SEBU8726-01).
Perkins 1104D-E Operation and Maintenance Manual
Genie part number
57.4700.0000
Perkins 854 Operation and Maintenance Manual
Genie part number
57.4700.0001
