Rev C
Instructions
Procedure
Part No. 219267
SmartLink Software Update
3
Procedure
Updating Machine Software
Note: If the firmware 137641J was previously
downloaded from the website or copied to your
computer from a thumb drive it must be
deleted from your computer before continuing.
1
Turn on the computer.
Note: If the firmware has been downloaded from
the website, continue to step 3.
Using a thumb drive:
2
Insert the thumb drive (Genie part
number 219205) in the USB port.
All applications:
Note: Disable all external internet or network
connections before continuing.
3
At the GCON, turn the key switch to the GCON
position.
4
At the PCON, pull out the red Emergency Stop
button to the on position.
5
At the GCON, press and hold the
Enter
and
Escape
buttons. Pull out the red Emergency
Stop button to the on position.
Result: The GCON LCD will display the
following screen.
1
LCD
2
ESCAPE button
3
ENTER button
6
Locate the diagnostic port on the side of the
GCON.
1
Diagnostic Port
7
Remove one of the fasteners securing the
cover and set aside. Loosen the other fastener.
Do not remove it.
8
Connect one end of a CAT5 Ethernet cable into
the diagnostic port. Connect the other end into
a PC or laptop.
Result: The GCON LCD will display the
following screen.
9
Read and record the IP address.
