Instructions
Rev C
Introduction
2 SmartLink
Software
Update
Part No. 219267
Introduction
Introduction
Observe and Obey:
This procedure shall be completed by a person
trained and qualified on the repair of this
machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Before Starting Installation:
Read, understand and obey the safety rules
and operating instructions in the appropriate
operator's manual.
Be sure that all necessary tools and parts are
available and ready for use.
Read this procedure completely and adhere to
the instructions. Attempting shortcuts may
produce hazardous conditions.
Indicates that a specific result is expected after
performing a series of steps.
Indicates than an incorrect result has occurred
after performing a series of steps.
Note: These installation instructions only apply
to the Genie models listed below, as required
by Safety Notice 120013.
GS-3232
GS-3246
Tools Required:
Laptop or desktop computer with an Ethernet Port
and Internet Browser
Torx T10 screw driver
CAT5 Ethernet cable of suitable length
Glossary of Terms
ECM - Electronic Control Module
GCON - Ground Controller. This ECM is located at
the ground controls.
PCON - Platform Controller. This ECM is located at
the platform controls.
CAT5 Cable - Standard Ethernet cable used for
networking purposes.
Components of Kit 219268
SmartLink Software Update Installation Instructions
Genie part number 219267
Qty. 1
Thumb drive
Genie part number 219205
Qty. 1
Includes:
Software SL1000, APP
Genie part number 137641
Qty. 1
