3. How the microcomputer operates
After switching ON unit (press the ON/OFF button for 3 seconds, until you hear a short beep),
weight of the barbell or stack is to be set using Up/Down buttons.
After each upward repetition:
-
Upper display shows average / peak power, partial average power average / peak velocity, and
peak force.
-
Middle display shows a percent value of the best repetition in particular set and eccentric
average velocity, if turned on.
-
Lower display shows repetition number and rest time, if turned on.
-
Preset parameter (avg / peak power, avg / peak velocity, partial avg power, peak
force) in the first repetition will be set 100%. Subsequent reps will be displayed as percentage of
this maximum. However, should any subsequent repetition be higher than previous 100%, it will
be considered as the new 100%. All subsequent reps will be compared to. If there is a multi
9
Upper display
Mode button
Middle display
ON / OFF button
Reset Button
Up button
Down button
Lower display
iButton reader
