9.2 Power, Velocity, Force measurement
After each repetition, the repetition number begins to display on the lower display, actual value of
average power, partial avg power and peak power, average velocity, peak velocity and peak force
on the upper display and percent value of the best repetition on the middle display.
It is possible to change the weight setting, even if data are measured, without resetting the
microcomputer unit. Go to setup menu and change the weight using Up and Down buttons.
To quit setup menu press Reset button.
The microcomputer will show you the exercise set data with different weight setting.
To view particular repetition, press Down or Up button. Prior the repetition with changed
weight, upper display will show "LoAd" and middle display will show new changed weight
for the following repetition.
If there are no measured data it is still possible to change the weight simply using Up and Down
button without necessity to enter to the setup menu.
To scroll down the parameters in upper display, press Mode button.
9.3. Deleting Data
Press Reset. This calls up delete process for all the data. Upper display shows "rSt" and middle
display shows "ALL". To delete all data, press Reset button, again.
To leave deleting process after the Reset button was pressed, press Up and Down button.
9.4 Deleting last repetition
Press the ON/OFF button. This calls up delete process for last repetition data. The Upper display
shows "dEL." Lower Display shows “Rep”. To delete last repetition, press ON/OFF again.
To leave deleting process after the ON/OFF button was pressed once, press Up and Down button.
9.5 Battery Saver
The microcomputer has a built-in battery saver to prolong the battery life. After 2 minutes of
microcomputer rest period, the battery saver is turned on (6 LED Mode lights flashing clockwise)
and the microcomputer switches off the displays. The battery saver is turned off automatically by
19
