Tenco 900-01201-000, Manual

Page: 23 / 35

9.04.02 H
OW TO ADJUST LABEL PHOTOCELL
The machine is fully-adjusted when it leaves the factory.
However, should it prove necessary to adjust the photocell because a type of paper other than that for
which it was originally set is used, proceed as follows:
For TELEMECANIQUE model
1) Power on the photocell: the LED 1 green turns on;
2) Position one label right by the reading head of the photocell;
3) Push SET button (the LED 1 green turns off) and keep it pressed until the LED 1 green starts
flashing;
4) Scroll the paper band in order to make the photocell detect the paper support within one label
and the next one;
5) Push SET button and wait the photocell to auto-calibrate; at the end only the green LED 1 is
turned on;
6) The calibration is complete: when one label is detected, the LED 2 yellow lights on.
Photo 9.7 Adjustment of the label photocell