Tenco 900-01201-000, Manual

Page: 28 / 35

9.04.05 L
ABEL POSITIONING ON THE BLADE
Warning: This adjustment must be performed after turning the machine off.
The labels must be positioned 3-4 mm out of the blade as in picture 9.10. If not, scroll manually the paper
to position the label 3-4 mm out of the blade, then adjust the label photocell as in picture 9.7 by moving the
photocell support.
Important: in case of combo reels, make sure that the label photocell is reading the same label as that
being positioned 3-4 mm out of the blade.
9.04.06 F
INAL CHECK
(
BEFORE INSERTING THE FIRST CONTAINER
)
1. Do not insert any container
2. Open completely the pressing roll
3. Close completely the pressing roll
4. The machine starts working and completes a whole work cycle.
5. Remove the label that has been flipped out and check that the next label is positioned 3-4 mm out of
the blade. If not, refer to par. 9.04.05 to adjust the label output.