Tenco 900-01201-000, Manual

Page: 30 / 35

Photo 9.14 The carriage is disengaged from the driving gear
Step 1) Remove the paper and re-insert it
following the paper path SCHEME 2 page
27.
Step 2) Check that the label is 1-2 mm out
of the label and that the label photocell is
in reading condition, as shown in photo
9.13;
Step 3) Now turn the machine on and
check the label output on the blade and the
label photocell positioning (don’t select the
SQUARE mode yet): simply open the
pressing roll A to start the work cycle and
perform all the required tests. If necessary
adjust the label output on the blade, ref.
par. 9.04.05.
Step 4) Loosen the screw 1, move the carriage up to its upper end, push it totally on the right, then tighten
the screw 1 photo 9.14 and release the carriage: the rack automatically engages in the gear that makes
the carriage move (photo 9.16).
Step 5) Put the container on the carriage and place it flush with the bottom platform by adjusting the
screws B and C photo 9.15.
Step 6) Adjust the upper pressing roll by acting on the screws F and G photo 9.15 in order to make it
press for 2-3 mm, as shown in the picture.
Photo 9.15 Adjustments for square/shaped containers