TEMPUR ZERO-G Platinum Series, Owner'S Manual

Page: 9 / 10

14 15
Unplug base from power source.
Detach the power-down box from both control boxes. Set aside.
Plug each end of the sync cord into the serial port where the power-
down box was previously plugged in.
Re-attach power down boxes to the sync cord splitter (see image).
Plug base back into the power source.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Both remotes will now operate both bases simultaneously.
setting up two bases
If simultaneous operation of two bases is desired, use the SmartSync ™ Cord to connect the
electronics of both bases together.
MUL
TIFUNCTION
6
RESET
PAIRING LED
7
MUL
TIFUNCTION
6
RESET
PAIRING LED
7
Power-Down Box Power-Down Box
Sync Cord
Splitter Splitter
Control Box Control Box
If any split setup is being installed, plastic connecting straps are provided (one per base) to secure
the bases together. Use both straps to secure the head and foot portions together.
With the bases in their desired location, slightly loosen both
legs to allow the strap to fit on the leg bolt, between the leg
washer and frame.
Slide side (a) of the connecting strap onto leg bolt. Swing the strap and
connect side (b) to the leg bolt. Secure the strap by shifting to the left.
Re-tighten legs. Do not over tighten. Use the remaining strap and
repeat on other end of the base.
STEP 2 STEP 1
STEP 3
setting up two bases
a
b