6
7
installation guide
To install the legs, thread the washer over the bolt of the leg with the
recessed side facing the leg, and tighten by hand.
Do not over tighten.
STEP 1
STEP 2
installation guide
Always use two people when setting up the base.
Place the bed base box in a desired location with the bottom of the
box facing up.
Remove the binding straps and packing materials, making sure not
to puncture the box with any sharp objects.
Remove the bed base from the box keeping the bottom of the base
facing upwards.
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
Uncoil input cord (connected to control box’s
power port) and plug into Power Supply.
To sync two bases with the SmartSync
™
cord - see page 14-15.
To install headboard brackets: See detailed installation
instructions on page 10-11.
Uncoil the Power Down Box from the frame and
install (2) 9 Volt batteries- not included.
Place box on the ground. Ensure that it is easily
accessible when the base is turned to its upright
position.
Uncoil the Power Cord and connect to the Power
Supply. Place Power Supply on the ground and
extend from the base. Ensure that the Power
Supply and all attached cords are directed toward
the desired surge protector.
Carefully flip the base over on to its legs.
Important:
Two people are
required to move the bed base. Do not drag across the floor. Do not rest
frame on its side, excessive pressure may damage the legs.
Plug the base into a power source.
A surge protector is strongly
recommended.
Ensure batteries are correctly installed in the back of the remote.
Quickly test functions to verify proper setup before placing mattress on base.
Press FLAT to return the base to a flat position.
Basic setup is now complete! See page 8-9 for remote control
operating instructions.
For customer support call: 1800 763 498 | NZ: 0800 443 292
For customer support call: 1800 763 498 | NZ: 0800 443 292
Slide the left side of the mattress retainer bar into the bracket. Pull the
retainer bar to the opposite bracket and secure the right side.
