14
Tempest MasterBelt Operating Manual
Pairing BeltStations to MasterBelt
Pair BeltStation to MasterBelt:
Confirm that the MasterBelt is powered ON and in Operational Mode (not in Menu Mode) and that
the BeltStation is powered OFF. Confirm that the MasterBelt’s Network Number and Lockout Key are
adjusted as needed. See the section on Set Network Number and Lockout Key.
Plug one end of the pairing cable into the MasterBelt and the other end into the BeltStation.
The pairing cable is a standard 3.5mm
(1/8 in.) Male to Male stereo patch cord.
Turn the BeltStation power ON by pressing and holding the BeltStation Power ON/OFF button for two seconds. The pairing process will begin
automatically. Watch for the message “Pairing Complete” to appear briefly on the BeltStation display. The BeltStation will automatically re-
initialize.
Name MasterBelt
Name the MasterBelt with a descriptive name. The MasterBelt name can include up to 14 characters. Prior to a name being assigned, a
hexadecimal serial number is displayed as a default.
The MasterBelt name will appear on the LCD Display, on the BeltStation LCD display, and in the BeltStation’s menu under “Select Base.”
To name each MasterBelt:
1. On the MasterBelt press MENU and select “Belt Settings,” then “Name BeltStation.”
2. Rotate the Volume control to move the underscore “_” to select the character to be changed.
3. Press ENT and notice the underscore changes to a pointer “^” under the selected character.
4. Rotate the Volume control to scroll through the character list. Press ENT to select the new character. Characters always replace and never
insert.
Repeat as needed.
5. Press ENT to save the new name after all characters are complete. Failure to press ENT to save will clear all changes.
6. Press MENU to escape to the Operation Mode screen.
Naming the BeltStation works the same as naming the MasterBelt.
