38 |
Rev 2.1 for firmware 5.0+ | http://www.temperaturealert.com/ | © 2011 Temperature@lert
Check Sensor Connections
Ensure there is at least one sensor connected to the sensor jacks on the side of
the unit. The unit does not have any built in sensors. Remove and reseat the
sensor from the jack and click the rescan button on the Alarm Settings page.
Contact support if you are unable to view a temperature reading with a sensor
cable connected.
No Humidity Reading
Humidity Sensors are Sold Separately
The base configuration of the Temperature@lert WiFi Edition includes one
temperature sensor. To obtain humidity readings, you will need to purchase a
second sensor. Visit http://www.temperaturealert.com to view the sensors
available for this unit
Perform the Steps for No Temperature Reading
The humidity sensor operates in a similar manner as the temperature only
sensor. Please perform the same steps as listed in the No Temperature
Reading section above.
Email [email protected] if you are unable to view a humidity
reading with a sensor cable connected.
Temperature Reading is a Few Degrees
Warmer than it Should Be
Check Sensor Position
If the sensor is positioned near the exhaust fan of a server or other heat
producing device, it will read a higher temperature than the rest of the area.
Comparing Apples to Apples
When comparing the temperature readings from the unit to another
thermometer, it's important to be mindful of the following:
Summary of Contents for TM-WIFI220
Page 1: ......
Page 2: ...1 Rev 2 1 for firmware 5 0 http www temperaturealert com 2011 Temperature lert...
Page 42: ......
