10 |
Rev 2.1 for firmware 5.0+ | http://www.temperaturealert.com/ | © 2011 Temperature@lert
Aux 2
- Light used for custom applications at the operating system level. Can
be programmed from the device's operating system.
100 Mbit
– Indicates 100 Mbit Ethernet connection / activity.
Connectivity Requirements
In order to operate properly and send email alerts when the sensor readings
fall outside your thresholds, the device requires Internet access via a wireless
or wired Ethernet connection.
Turning on the Hardware
Connect one or two sensors to either jack on the side of the device (see figure
1). Note: The device does not have any built in sensors.
Plug the AC adapter into a wall outlet and connect the power to the device.
Please wait about 60 seconds for the device to finish booting up. Your device is
now ready to connect to your PC.
Connect an Ethernet cable to your computer and to the Ethernet jack of the
Temperature@lert WiFi unit.
Connecting to the Web Based Admin
Interface
For initial setup, ensure the unit is connected
directly
to your computer's
Ethernet port. If your computer’s Ethernet adapter is set to acquire an IP
address, via DHCP, the WiFi device will assign it an address. Otherwise, you will
need to configure a static IP address on the same subnet as the WiFi device
(such as 10.99.99.2). The default IP/subnet of the device is 10.99.99.1 /
255.255.255.0
Open a web browser and browse to
http://10.99.99.1/
.
Summary of Contents for TM-WIFI220
Page 1: ......
Page 2: ...1 Rev 2 1 for firmware 5 0 http www temperaturealert com 2011 Temperature lert...
Page 42: ......
