Temperature@lert TM-WIFI220, User Manual

Page: 19 / 42

18 |
Rev 2.1 for firmware 5.0+ | http://www.temperaturealert.com/ | © 2011 Temperature@lert
If you connect new sensors or change which ports the sensors are connected
to, you will need to press the ‘Reset Sensors’ button. Pressing the ‘Reset
Sensors’ button will erase the data and alarms associated with the unit. The
unit will automatically reboot after pressing ‘Reset Sensors’, detecting the new
sensors. One the unit has rebooted the alarms can now be set in on the ‘Alarm
Settings’ tab.
Connection Settings
Your Temperature@lert device can connect to the internet through a wired
Ethernet cable or wirelessly if you have wireless network. Initial set up of the
device must be done through the Ethernet cable, after the initial set up the
device can be configured to operate on your wireless network.
Current Wireless IP – Once the Temperature@lert unit has successfully
connected to your wireless network, an IP address will be displayed here. Type
this IP into your browser to view the device.
Current Ethernet IP – This is the IP that you can use to access the unit if it is
connected via Ethernet. Type this IP into your browser to view the device.
Wireless/Ethernet MAC – The MAC address associated with each connection
type is displayed.
Connect to Internet Via – Choose how you would like the device to connect to
the internet. To connect via Ethernet skip to the next section, for wireless
connection follow the steps below.