36 |
Rev 2.1 for firmware 5.0+ | http://www.temperaturealert.com/ | © 2011 Temperature@lert
Troubleshooting
Unit Does Not Power On
Check to make sure the unit is connected to wall power with the included
power adapter or the unit is connected to a PoE connection with a power
injector. PoE via powered hub or switch is not support. You must use a power
injector if you choose to utilize PoE. If you are still unable to power on your
unit (indicated by the power light on the front), please contact
[email protected]
Cannot Connect to the Web Admin Interface
Check Connections
Ensure the unit is receiving power. For initial setup, ensure the unit is
connected
directly
to your computer's Ethernet port. Do not connect the unit
to a router, switch or hub for initial setup. After you connect the power, you'll
need to wait about 1 minute for the device to fully boot up.
Check the Computer's Ethernet Settings
You'll also need to be sure your computer's Ethernet card is set to obtain an IP
address automatically. If you still have trouble connecting to the unit's built in
web based administrative interface, please contact
[email protected]
Cannot Send Email
Check Internet Connectivity
Before email can be sent, the unit must be configured for Internet access.
Internet access can be setup on either the wired or wireless connections. See
the section above titled Connection Settings.
Summary of Contents for TM-WIFI220
Page 1: ......
Page 2: ...1 Rev 2 1 for firmware 5 0 http www temperaturealert com 2011 Temperature lert...
Page 42: ......
