19
If the Guard has called all programmed contact numbers without having the correct PIN number en-
tered, it will wait 20 minutes and repeat the sequence until the alarm condition goes away or the Guard
receives confirmation either locally or remotely.
How can I connect the Guard to a Phone Line which has a fax or answering machine connected
to it?
Program the Guard to answer after one more ring than the other device. This allows the other device
to always answer first. To call and access the Guard
1. Dial the phone number.
2. Hang up one ring before the other device answers.
3. Wait no longer than 30 seconds, then dial the phone number again.
4. The Guard will answer.
For Example:
A fax machine on the same line as the Guard is set to answer after 4 rings. The Guard is programmed
to answer after 5 rings. To access the Guard, dial the number, let it ring three times, then hang up.
Wait 20 seconds and call again. After two rings, the Guard will answer.
What is the difference between the different models?
The VM605E and the V610E have network adapters on them, allowing the use of the Data Capture
software and onboard data collection.
The VM605 and the VM605E are calibrated for refrigerators and freezers.
-148°F to 69°F is the calibrated range.
The VM610 and the VM610E are calibrated for refrigerators and incubators.
32°F to 147°F is the calibrated range.
How do I delete a phone number?
See page 11 step 8
How do I remove a sensor without it alarming constantly?
See page 5
Can I set the IP address without your software?
Yes. Open a browser and type the following, changing the IP address to the IP address of your unit.
http://192.168.0.73/secure/ltx_conf.htm (this is an example) Default login name and password are
both blanks. Enter nothing, just hit enter.
Telnet may also be used. From a cmd prompt, telnet 192.168.0.73 9999 (again this is an example)
telnet space IP address space 9999
