P a g e
| 19
TEMELSAN MAKİNA SAN. VE TİC. LTD. ŞTİ.
Akçaburgaz Mah. Muhsin Yazıcıoğlu Cad. No:55/1 Esenyurt / İstanbul / TÜRKİYE
TEL: +90 (212) 544-2518 FAX: +90 (212) 577-6557 www.temelsan.com [email protected]
•
Over feed
•
Lack of band tension
•
Tooth set damage
•
Loose guide arms or set
too far from work
•
Check your cutting chart
•
Check Operator's Manual for
correct tension
•
Check material hardness
•
Adjust arm as close to work as
possible - tighten and align.
Check guide
•
Improper or lack of
cutting fluid
•
Wrong coolant
•
Excessive speed or
pressure
•
Incorrect blade (wrong
pitch)
•
Check your coolant
•
Check your coolant
•
Reduce speed or pressure.
Check your cutting chart *
•
Check your coolant
•
Incorrect feed and/or
speed
•
Incorrect blade (wrong
pitch)
•
Saw guides not adjusted
properly
•
Check your cutting chart
•
Check your cutting chart
•
Adjust or replace saw guides
•
Indexing out of sequence
•
Material loose in vise
•
Check for correct indexing
sequence (head rise)
•
Check hydraulic pressure
•
Feed pressure too high
•
Tooth lodged in cut
•
No cutting fluid or incorrect
coolant
•
Hard spots, scale,
inclusions, etc.
•
Incorrect blade (wrong
pitch)
•
Work spinning in vise; loose
"nest" or bundles
•
Reduce feed pressure and/or
speed. See your cutting chart
•
Never enter same (old blade), cut
with new blade
•
Check your coolant
•
Check hardness. Descale and/or
anneal if necessary
•
Check your cutting chart
•
Check hydraulic pressure; be
sure work is firmly held