P a g e
| 18
TEMELSAN MAKİNA SAN. VE TİC. LTD. ŞTİ.
Akçaburgaz Mah. Muhsin Yazıcıoğlu Cad. No:55/1 Esenyurt / İstanbul / TÜRKİYE
TEL: +90 (212) 544-2518 FAX: +90 (212) 577-6557 www.temelsan.com [email protected]
Problem
Probable Cause
Solution
•
Incorrect blade
•
Band tension too high
•
Excessive feed
•
Incorrect cutting fluid
•
Wheel diameter too small
for blade being used
•
Worn or chipped
pressure block (back-up
guide)
•
Blade rubbing on wheel
flanges
•
Teeth in contact with
work before starting saw
•
Side guides too tight
•
Teeth too coarse. Check your
cutting chart
•
Reduce band tension. See
Machine Operator's Manual
•
Reduce feed pressure
•
Check your coolant
•
Use thinner blade and lower
speed
•
Check pressure block. Replace
if worn
•
Adjust wheel alignment
•
Allow 1/2" clearance before
starting cut
•
See Machine Operator's
Manual
•
Blade teeth inverted
(backwards)
•
Improper break-in period
•
Hard spots in material
(like scale)
•
Material work hardened
(check for hardness and
adjust feed)
•
Improper cutting fluid or
mixture
•
Speed and feed too high
•
Install blade correctly
•
Reduce feeds and speeds
during break-in period in
accordance with
manufacturers'
recommendations
•
Check material for actual
hardness - hard spots like
scale or flame cut surfaces
•
Increase feed pressure
•
Check your coolant
•
Check your cutting chart
•
Teeth dull
•
Over or under feed
•
Improper pitch blade
•
Cutting fluid not applied
evenly
•
Incorrect blade (too
many teeth per inch)
•
Guides worn or loose
•
Use new blade
•
Check your cutting chart
•
Check your cutting chart
•
Adjust coolant nozzles
•
Check your cutting chart
•
Tighten or replace guides