36
5.13
Features settings
For more information about available Scenarios, Trip, Geofencing and iButton list, refer to
5.4 chapter.
5.13.1
Scenarios settings
In Scenarios window four different scenarios are available, three for Digital Output 1 and
two for Digital Output 2 (DOUT). Only one per digital output can be active at a same time, e.g.
DOUT1 can have either Green driving, Over Speeding or Jamming detection enabled, DOUT2 can
have either Authorized Driving
or
Immobilizer enabled.
Figure 31 Scenarios configuration
Digital Output (open drain grade) usage in scenarios:
Green Driving
DOUT1 is ON for:
3sec. if detected value is over (0; 30] % from preconfigured allowed value
5sec. if detected value is over (30; 50] % from preconfigured allowed value
7sec. if detected value is over (50; -] % from preconfigured allowed value
After period of time DOUT1 is turned OFF.
Over Speeding
DOUT1 is ON, while vehicle speed exceeds parameter value. DOUT1 is activated until
current speed decreases below parameter value.
Jamming Detection
DOUT1 scenario. When this scenario is enabled and device
modem is being jammed DOUT1 is turned on. When jamming stops DOUT1 is turned off.
Authorized driving
DOUT2 is continuously OFF. Dout2 turns ON if Ignition turns ON (configured Ignition
Source=1). After authorizing iButton (iButton ID is read and it matches the ID from the iButton
list), DOUT2 turns OFF. After successful authorization ignition can be turned OFF (configured
Ignition Source=0) for no longer than 30 seconds, otherwise authorization must be repeated.
Immobilizer
