Note:
To ensure that the line stays silent and cannot dial out if held off-hook
at the end of a call, set the tone following disconnect command to silence:
*39#1#
·
To put this line in silent mode so that no dial tone is provided and the line
will not respond to dialing, enter:
*
32#2#
33:
Audio Port Permission
This command permits or denies access to the audio port. (This command
does
not
affect the audio port access for command 31.)
·
To disable audio access from this line, enter:
*
33#0#
Note:
If command 05, Audio Port Access, is set to monitor for tone
(*05#3#y#z#), you will be unable to disable access.
·
To enable audio access from this line
(default)
, enter:
*
33#1#
34:
Flash Detection
This command determines whether or not the TLS-4A will recognize a “flash”
issued on this line.
A flash is used to signal for services such as calling an attendant, setting up a
conference call, or transferring a call. A flash can be executed either by using
the FLASH button (on phones that have one) or by momentarily pressing the
switch in the telephone handset cradle (don’t do both).
·
To disable switchhook flash detection; callers on this line will not be able
to transfer calls or exercise other PBX-like functions, enter:
*
34#0#
Note:
If you disable switchhook flash detection, the on-hook detect time will
be shorter. In this situation, a switchhook flash could result in a disconnect.
·
To enable switchhook flash detection (
default
), enter:
*
34#1#
Telephone Line Simulator 4A
Page 36
