Step 3:
Hang up on answer
·
After the third party answers, hang up.
To use the audio port:
·
See the Using the Audio Port section.
To test equipment functioning:
·
See Chapter 5.
To enable flash detection:
This procedure is not necessary unless flash detection was disabled by a
previous user.
Step 1:
Access Program Mode On Line 1
·
Lift the handset. Press and hold the switch in the MAN/RING position
until the Line 1 light blinks and confirmation tone (three beeps) is heard.
Step 2:
Enter command
·
With a telephone plugged into Line 1, enter the following:
*
34#1#
·
Listen for three beeps indicating that the command is accepted. If you do
not hear the beeps, refer to Chapter 6, Programming.
Step 3:
Hang up
·
Hang up the telephone.
On Lines 2, 3, or 4:
Step 1:
Access Program Mode
·
Lines 2, 3, and 4 must be on-hook. Lift the handset at the telephone
connected to Line 1.
·
Press and hold the switch in the MAN/RING position until the Line 1 light
blinks and you hear three beeps.
Reference Manual
Chapter 4: Operation
40-400-00033, Rev.
C
Page 11
