Chapter 7: Record & Play Back Messages
Notes:
(1) Recording of telephone conversations is subject to FCC regulations. See page 5 for
compliance requirements.
(2) The recorder tone option is not provided by the T-311.
Connecting the T-311 to the Recording Device
A standard cassette player interface cable, with a mating 5-pin DIN connector at one end and three
cable plugs at the other is required (see Figure 5). This cable is connected as follows:
•
Plug the 5-pin connector into the T-311 connecting jack labeled “Remote”.
•
Connect the black cable plug to the “Earphone” jack on the recording device.
•
Connect the small gray cable plug to the “Remote” jack on the recording device.
•
Connect the larger gray cable plug to the “Aux” jack on the recording device. (If the recording de-
vice has no “Aux” jack, connect this cable plug to the “Mic” jack.)
Recording from the Line
Step 1: Connect T-311 to Recording Device
•
Connect the T-311 to the recording device as described above.
Step 2: Enable Record
•
Enable the record function. Typically, this requires pressing both the “Play" and the “Record” but-
tons on the recording device. (No recording will take place until you establish a call and issue a
“begin recording” command through the T-311 using either of the methods described in Steps 3
and 4 below.)
Step 3: Delayed Recording Start:
•
Place a call through the T-311 by issuing a “D” command at the computer or through an applica-
tion program (see Chapter 8 for more information on commands).
•
Start the recording at any time after the connection is established by issuing the command
AT*R1<CR>.
Step 4: Immediate Recording Start
•
If you want to start recording as soon as the call is connected, issue an “H2” command in con-
junction with the “D” command. For example: ATH2 D123-4567.
Step 5: Stop Recording
•
To stop the recording without terminating the call, issue the command AT*R<CR>. The recording
will be stopped automatically when you use an H command to hang up the line.
Playing Back to the Line
Step 1: Connect T-311 to Recording Device
•
See “Connecting the T-311 to the Recording Device” on page 19.
Note:
If you need to use the “Rewind” or “Fast Forward” functions to position the message, issue an
“H2” command, then rewind or fast forward, then issue an “H” command.
Reference Manual
Chapter 7: Record & Play Back Messages
40-400-00045, Rev.
B
Page 19
