Telstra Elite, User Manual

Page: 92 / 100

TELSTRA ELITE™ GATEWAY USER GUIDE
92
Name Description
Log
Indicates whether the system is currently recording events. You can enable or
disable event logging. By default, it is disabled.
Log level
Allows you to configure the event level and filter out unwanted events below this
level. The events range from the highest critical level
“Emergency” down to this configured level will be recorded to the log buffer on
the gateway’s SDRAM. When the log buffer is full, the newest event will wrap up to
the top of the log buffer and overwrite the oldest event. By default, the log level is
“Debugging”, which is the lowest critical level. The log levels are defined as follows:
Emergency is the most serious event level, whereas Debugging is the least
important. For instance, if the log level is set to Debugging, all the events from the
lowest Debugging level to the most critical level emergency level will be recorded. If
the log level is set to error, only error and the level above will be logged.
Display Level
Allows you to select the logged events and displays on the View System Log window
for events of this level and above to the highest emergency level.
Mode
Allows you to specify whether events should be stored in the local memory be sent
to a remote syslog server, or to both simultaneously. If remote mode is selected, the
view system log will not be able to display events saved in the remote syslog server.
When either Remote mode or Both mode is configured, the Web UI will prompt the
you to enter the Server IP address and Server UDP port where syslog is running.
3: Click View System Log. The results are displayed as follows.