10
Getting started
4. Place your Telstra CR2000 MKII cordless rental phone over the two retaining screws of your
standard Telstra wall mount plate. Slide the phone downward into position as indicated.
To remove the stand from the Wall mount
position
Referring to the diagram below, slide the stand
upward until it releases from the locking
grooves, then lift the stand out.
WARNING
Do not place your Telstra CR2000 MKII cordless
rental phone in the bathroom or other humid
areas.
IMPORTANT
The base station must be plugged into the
mains power socket at all times. Do not
connect the telephone line until the handset is
fully charged. Only use the power supply,
telephone cables and NiMH rechargeable
batteries supplied with the product.
Low battery warning
If the icon
flashes in the handset display,
you will need to recharge the handset before
you can use it again. During charging, the icon
will appear to be filling in the display.
Battery performance
In ideal conditions, the fully charged batteries
should give up to 12 hours talk time, or 100
hours standby time, on a single charge.
To keep the batteries in the best condition,
leave the handset off the base for a few hours
at a time. Running the batteries right down at
least once a week will help them last as long as
possible. The charge capacity of the
rechargeable batteries will reduce with time as
they wear out, giving the handset less talk /
standby time. Eventually they will need to be
replaced. Replacement batteries can be
obtained from your local electrical retailer.
Note: New batteries will not reach full capacity until
they have been in normal use for several days.
11
Getting started
After charging your handset for the first time,
subsequent charging time is about 6-8 hours a
day. The batteries and handset may become
warm during charging, however, this is normal.
Using your Telstra CR2000 MKII cordless
rental phone on a Broadband ADSL line?
If this product is to be used on a broadband
ADSL line, then you must ensure that it is
connected via an ADSL filter. Using this product
on a Broadband line without an ADSL filter
may cause problems with this product and
your Broadband service.
Date and time
If you have subscribed to Telstra's Calling
Number Display service, the date and time is
set automatically for all handsets when you
receive your first call. You may however have
to manually set the correct Year by following
instructions below. If you have not subscribed
to Telstra's Calling Number Display Service, you
can set the date and time manually.
Set date and time manually
1. In standby mode, press
Menu
.
2. Scroll
or
to
Clock & Alarm
.
3. Press
Select
to access
Date & Time
.
4. Press
Select
then use the keypad to enter
the date and time.
5. Press
Save
then
Back
to return to previous
menu level or press
!
to return to standby.
Note: Use the
or
to toggle between am/pm for
12H clock mode.
Summary of Contents for CR2000 MKII
Page 24: ...46 47...
