AKTUAL RPM
29
ALARM LIMITS: 20-30
The 20 - 30 indicates the programmed limits of
the wrapping speed. Should the speed exceed 30
rpm or fall below 20 rpm, the audio alarm will
sound if engaged and the display will show this
message.
“
Actual RPM “
is the wrap arm speed at any
given instant.
BALE COUNTERS
Press SET to enter.
The system contains 10 bale counters. When this
disply is shown, it is possible to inspect the bale
counters. Machine total ( the sum of all bales ever
made on the machine.) And the quantity of each
individual bale counter.
WORKING HOURS: 122
MACHINE TOTAL: 798
Displays the number of working hours of the
machine in 1 week, day or other (resettable) and
the total number of the machine operating hours.
(Not a resettable facility).
LANGUAGE: ENGLISH
The system may contains a number of languages
for all SETUP parameters, messages and operator
instructions. The language required for display
messages may be chosen ( if available ) via this
meny.
AUDIOALARM &
DISPLAY
Press SET to enter
The contrast adjustment needed depends on the
viewing angle and the light conditions in the
cabin. 100 is maximum contrast and 0 is
minimum. The contrast may at all times be
readjusted on the MENU up / down buttons
without entering this display. The contrast setting
is preset to 50.
HARDWARE TEST
Press SET to enter
The hardware test programme is a tool facility
enabling and inspect almost all functions,
switches and push buttons on the system.
It also contains a battery supply voltmeter which
automatically will be displayed should the voltage
drop below 8 volt during the operation.
SETTING UP THE SYSTEM:
All functions are preadjusted from the TELLEFSDAL factory and commonly the only adjustment
which the operator needs to make, is the programmed number of film layers required.
TYPICAL OPERATOR PROGRAMMATION.
( Standard for all machine models.)
1: Required number of film layers. (Changing from 20 to 25 layers.)
2: Bale counter selection.
* Emergency stop: see chapter 2.1
20
