SE868-V3 Product User Guide
1VV0301205 r4 – 2016-01-20
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 75 of 76
Mod. 0805 2015-02 Rev.4
18.
Safety Recommendations
READ CAREFULLY
Be sure that the use of this product is allowed in the country and in the environment required.
The use of this product may be dangerous and must be avoided in the following areas:
•
Where it can interfere with other electronic devices in environments such as hospitals,
airports, aircraft, etc.
•
Where there is risk of explosion such as gasoline stations, oil refineries, etc. It is the
responsibility of the user to enforce the country regulation and specific environmental
regulations.
Do not disassemble the product. Evidence of tampering will invalidate the warranty.
Telit recommends following the instructions in product user guides for correct installation of
the product. The product must be supplied with a stabilized voltage source and all wiring must
conform to security and fire prevention regulations. The product must be handled with care,
avoiding any contact with the pins because electrostatic discharges may damage the product
itself.
The system integrator is responsible for the functioning of the final product; therefore, care
must be taken with components external to the module, as well as for any project or installation
issue. Should there be any doubt, please refer to the technical documentation and the regulations
in force. Non-antenna modules must be equipped with a proper antenna with specific
characteristics.
The European Community provides some Directives for electronic equipment introduced on
the market. All the relevant information are available on the European Community website:
http://ec.europa.eu/enterprise/sectors/rtte/documents/
The text of the Directive 99/05 regarding telecommunication equipment is available, while the
applicable Directives (Low Voltage and EMC) are available at:
http://ec.europa.eu/enterprise/sectors/electrical/
The power supply used shall comply the clause 2.5 (Limited power sources) of the standard
EN
60950-1
and the module shall be mounted on a PCB which complies with V-0 flammability
class.
Since the module must be built-in to a system, it is intended only for installation in a
RESTRICTED ACCESS LOCATION. Therefore, the system integrator must provide an
enclosure which protects against fire, electrical shock, and mechanical shock in accordance
with relevant standards.
