TeleWell TW-EA200, Manual

Page: 64 / 91

Chapter 3 Installation and Configuration
27
3.4.3.2 LAN
This screen contains settings for LAN interface attached to the LAN port.
IP Address: Default at 192.168.0.254
.
This is the device IP address in LAN site. If you plan to change it to another IP address to a
different range of IP subnet. Please make sure your PC is also located at the same IP subnet.
Otherwise, you may not be able to access the router.
Subnet Mask: Default at 255.255.255.0.
DHCP Server:
Check DHCP Server to enable the router to distribute IP Addresses, subnet mask
and DNS setting to computers. Hence, the following fields will be activated. If you do not check
this selection, remember to specify a static IP address, subnet Mask, and DNS setting for each of
your local computers. Be careful not to assign the same IP address to different computers.
Address pool selection:
Auto or User Defined. If select the AUTO, router will assign an IP
address back to PC’s IP request. If User Defined, please specify the IP pool range.
Start Address:
Enter the start address of this local IP network address pool. The pool is a piece
of continuous IP address segment. The default value is
192.168.1.100
.
End Address:
Enter the last address of this local IP network address pool that you want the
DHCP server to assign IP addresses to. The default value is
192.168.1.199
.
With this case, the DHCP pool is from 192.168.1.100 to 192.168.1.199. Therefore, the local
computer will get an IP address located at this range randomly.
3.4.3.3 System
There are six items under the
System
section: Password, Time Zone, Upgrade, Factory Setting,
and Reboot.